Emerson MMI-20019043 Manuel D’Utilisation

For some faults only: If Last Measured Value Timeout is set to a non-zero value, the transmitter will not
implement the fault action until the timeout has elapsed.

1.

Set Frequency Output Fault Action as desired.

The default value is Downscale (0 Hz).

2.

If you set Frequency Output Fault Action to Upscale, set Frequency Fault Level to the desired
value.

The default value is 15000 Hz. The range is 10 to 15000 Hz.

Upscale

Goes to configured Upscale value:

•

Range: 10 Hz to 15000 Hz

•

Default: 15000 Hz

Downscale

0 Hz

Internal Zero

0 Hz

None

 (default)

Tracks data for the assigned process variable; no fault action

If you set mA Output Fault Action or Frequency Output Fault Action to None, be sure to set Digital
Communications Fault Action

 to None. If you do not, the output will not report actual process data,

If you set Digital Communications Fault Action to NAN, you cannot set mA Output Fault Action or Frequency
Output Fault Action

 to None. If you try to do this, the transmitter will not accept the configuration.

The discrete output is used to report specific flowmeter or process conditions. The discrete
output parameters control which condition is reported and how it is reported. Your
transmitter may have zero or one discrete output: Channel B can be configured as a
frequency output or a discrete output.

The discrete output parameters include:

•

Discrete Output Source

Integrate the meter with the control system

114