Telex IFB-1000 Fascicule
GENERAL
The Audiocom
®
IFB-1000 is a one-channel listen only IFB belt pack.
OPERATION
SYSTEM POWER
The IFB-1000 belt pack receives power externally, via the intercom
channel.
The IFB-1000 belt pack receives power externally, via the intercom
channel.
IFB-1000 SETUP
The channel termination is set for balanced operation, which is compat-
ible with other Audiocom equipment.
The channel termination is set for balanced operation, which is compat-
ible with other Audiocom equipment.
The headset/earset jack is set for 150 ohm operation.
EXTERNAL CONNECTIONS & CONTROLS
1
2
4
HEADSET
3
IFB-1000
1. Volume Control.
Use this control to adjust the headset/earset listen level.
2. On Indicator
This LED glows green when the belt pack is connected to an intercom
channel that is functioning.
channel that is functioning.
3. Headset Connector
This connector accepts a wide-response earset, such as the Telex
EMV-2 (catalog number 60194-001), with a 1/4” monaural phone plug.
EMV-2 (catalog number 60194-001), with a 1/4” monaural phone plug.
4. Intercom Channel Connectors
The IFB-1000 intercom channel is connected via a 3-pim female
connector. The IFB-1000 is powered from the intercom system power
supply and will turn on with the intercom system.
connector. The IFB-1000 is powered from the intercom system power
supply and will turn on with the intercom system.
CONNECTOR PIN CONFIGURATIONS
HEADSET CONNECTOR
Type: 1/4” Monaural Plug
Sleeve Headset audio low
Tip
Tip
Headset audio high
INTERCOM CHANNEL CONNECTORS
Type: XLR-3F
Pin 1
Common
Pin 2
Intercom audio and +24 VDC input
Pin 3
Intercom audio and +24 VDC input
SPECIFICATIONS
GENERAL:
Channel Supplied Power Requirements:
+24 VDC nominal (standard Audiocom line), 50 to 80 mA
Environmental Requirements:
Storage: -20°C to 80°C; 0% to 95% humidity, non-condensing
Operating: 0°C to 50°C; 0% to 95 % humidity, non-condensing
Operating: 0°C to 50°C; 0% to 95 % humidity, non-condensing
Dimensions:
3.25” (82.6 mm) H x 3.5” (88.9 mm) W x 1.8” (45.7 mm) D
Weight:
1.0 pounds (0.45 kg)
INTERFACE REQUIREMENTS:
Earset:
150 to 600 ohm headphones
Balanced Intercom Channel Level & Impedance:
1 Vrms nominal; 300 ohms ±5%
Noise Contribution:
Less than -60 dB on the line.
HEADPHONE AMPLIFIER:
Voltage Gain:
27 ±3 dB from the line
Maximum Output:
60 mW into 150 ohms
Frequency Response:
200 Hz to 8 kHz +1/-3 dB