Canon LV-8225 Manuel D'Instructions

54

This function enables you to capture an image being 

projected to use it for a starting-up display or interval of 

presentations.

Select 

Capture and press the OK button.  

A confirmation box appears and select 

Yes to capture 

the projected image.

After capturing the projected image, go to the Logo 

select function and set it to 

User. Then the captured 

image will be displayed the next time you turn on the 

projector or when you press the BLANK button (p 9). 

To cancel the capture function, select 

Yes in the "Quit?" 

confirmation box.



  • Before capturing an image, select 

Standard in the Image select Menu to 

capture a proper image (pp. 35,44).

  • A signal from a computer can be captured 

up to XGA (104 x 768). A signal from video 

equipment can be captured except for 

720p, 1035i, and 1080i. (Only for LV-790, 

LV-795, LV-7390)

  • A signal from a computer can be captured 

up to WXGA (180 x 800). A signal from 

video equipment can be captured except 

for 

1035i and 1080i. (Only for LV-85)

  • When capturing the image that has been 

adjusted by the Keystone function, the 

adjusted data is automatically reset and 

the projector captures an image without 

keystone correction. 

  • When Logo PIN code lock function is set to 

On, Logo select and Capture can not be 

selected.  

  • When starting to capture a new image, the 

previously stored image is cleared even if 

you cancel the capturing.

  •  When there is no captured image or it is 

interrupted while capturing an image, 

User 

can not be selected, you can only switch 

between 

Default and Off.

This function prevents an unauthorized person from 

changing the screen logo.

 

Off ........... The screen logo can be changed freely 

from the Logo Menu (p. 53).

 

On............ The screen logo cannot be changed 

without a Logo PIN code.

If you want to change the 

Logo PIN code lock setting, 

press the OK button and the Logo PIN code dialog box 

appears. Enter a Logo PIN code by following the steps 

below. The initial 

Logo PIN code is set to “431” at the 

factory.