Q-Logic 2400 Manuel D’Utilisation

6–iSCSI Noninteractive Commands
-strd

6-26

SN0054667-00  C

To execute a rediscovery of targets for the specified send target, issue the -strd 

command as follows:

-strd <hba_port_inst> <target_instance>

To obtain the target instance, use the -dtdsp command.
To use the -strd command, you must first issue the -stadd command at least 

once to add a send target for discovery only. For more information, see 

.

To remove the specified send target, issue the -strem command as follows:

-strem <hba_port_inst> <target_instance>

To obtain the target instance, use the -dtdsp command.
To use the -strem command, you must first issue the -stadd command at least 

once to add a send target for discovery only. For more information, see 

.

To remove all send targets, issue the -strema command as follows:

-strema <hba_port_inst> <target_instance>

To view target information, issue the -t command as follows:

-t <hba_port_inst> [Target ID]

If you only specify the <hba_port_inst> parameter, QConvergeConsole CLI 

lists target information for all targets on the specified adapter port. If you specify 
the optional parameter [Target ID], QConvergeConsole CLI lists information 

on the specified target only. This includes both persistent and dynamic targets.

To set target parameter settings, use the -tc command. For a list of target 

parameters you can configure, issue the following command:

-tc <hba_port_inst> < Target_ID > <config_name | config_alias> 
<value> <config_name | config_alias> <value>