Honeywell HEGS5000 Manuel D’Utilisation

 

Cameras 

3.0 

Used to set the type of camera and the address to 
which the controller sends commands when this camera 
is selected on the monitor or spot monitor if the 
controller is in Mux Mode .  Press Enter (

) to access 

this menu. 

Camera Num 

3.1 

Camera Number – use the number keys or the 

 and 

keys to select the camera number. 
 
Once the camera number is selected, press Enter (

) 

to move to the next submenu. 

(Cam Num) Type 

3.1.1 

Used to select the type of camera for each camera 
number.  The camera number in parentheses indicates 
which camera is currently selected. 

 
To set camera type, use the 

 and 

keys to select 

between the four camera types (KD6/HD6, KD6-Z, Fixed 
Camera, and Pan Tilt Head). 

 
Press Enter (

) or joystick tilt down to move to the 

next submenu. 

Tip:  To make it easy to setup camera TYPES and camera ADDRESSES, start with Camera 1 
TYPE and simply press Enter (

) after setting the type to go to the address.  Set the address 

and then press Enter (

) to move to the TYPE for camera 2.  Continue setting the TYPE and 

ADDRESS for each subsequent camera until all cameras are done. 
(Cam Num) Address 

3.1.2 

Used to set the camera address.  The camera number in 
parentheses indicates which camera is selected. 
 
Enter the required address of the camera using the 
number keys or the 

 and 

keys.  For KD6-Z domes, 

the address must be the same as the value set in menu 
5.0 setup. 

 
Press Enter (

) to move to the next camera.   

Press Clear/Manual  (

) to exit this menu. 

 

Rev. 1.01 

15 900.0800 

  

19-Jun-06