3com WX1200 3CRWX120695A Manuel D’Utilisation

Specifies the name of the SSID a Mesh AP attempts to associate with 
when it is booted.

Syntax — 

set ap ap-number boot-configuration mesh ssid 

„

ap ap-number

 — Index value that identifies the MAP on the WX.

„

— Name of the mesh SSID (up to 32 characters).

 — 

None.

 — 

Enabled.

 —

Introduced in MSS Version 6.0.

 — 

You must connect the MAP to a WX switch and enter this 

command to 

specify the mesh SSID prior to deploying the Mesh AP in its 

final untethered location. When the MAP is booted its untethered 
location, and it determines that it has no Ethernet link to the network, it 
then associates with the specified mesh-ssid.

Note that when the mesh-ssid is specified, the regulatory domain of the 
WX and the power restrictions are copied to the MAP flash memory. This 
prevents the Mesh AP from operating outside of regulatory limits after it 
is booted and before it receives its complete configuration from the WX. 
Consequently, it is important that the regulatory and antenna information 
specified on the WX actually reflects the locale where the Mesh AP is to 
be deployed, in order to avoid regulatory violations.

 — 

The following command configures MAP 7 to attempt to 

associate with 

the SSID wlan-mesh when booted in an untethered 

location:

WX# set ap 7 boot-configuration mesh ssid wlan-mesh

success: change accepted.

„

„

„