3com WX1200 3CRWX120695A Manuel D’Utilisation
set igmp qi
531
set igmp qi
Changes the IGMP query interval timer on one VLAN or all VLANs on a
WX.
WX.
Syntax —
set igmp qi seconds [vlan vlan-id]
qi seconds
— Number of seconds that elapse between general
queries sent by the WX when the WX switch is the querier for the
subnet. You can specify a value from 1 through 65,535.
subnet. You can specify a value from 1 through 65,535.
vlan vlan-id
— VLAN name or number. If you do not specify a
VLAN, the timer change applies to all VLANs.
Defaults — The default query interval is 125 seconds.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Usage — The query interval is applicable only when the WX is querier for
the subnet. For the WX switch to become the querier, the pseudo-querier
feature must be enabled on the WX and the WX must have the lowest IP
address among all the WX switches eligible to become a querier. To
enable the pseudo-querier feature, use the set igmp querier command.
the subnet. For the WX switch to become the querier, the pseudo-querier
feature must be enabled on the WX and the WX must have the lowest IP
address among all the WX switches eligible to become a querier. To
enable the pseudo-querier feature, use the set igmp querier command.
Examples — The following command changes the query interval on
VLAN orange to 100 seconds:
VLAN orange to 100 seconds:
WX1200# set igmp qi 100 vlan orange
success: change accepted.
See Also