Cal Flame G4 Manuel D’Utilisation
Appendix
17
2009 G3, G4, G5 Grills
LTR20091050, Rev. A
www.calspas.com
Troubleshooting
Problem: Smell of gas is present
Solution: Check for loose connections in the gas line. Perform
Solution: Check for loose connections in the gas line. Perform
a leak test following the procedure described in this
manual.
Problem: Burner does not ignite
Solution: Use the following procedure with the figure below.
Solution: Use the following procedure with the figure below.
Check the position of the sparker tip. It should be
pointing forward towards the front of the burner.
Make sure there is a blue spark at the electrode tip
•
to the burner.
Make sure the igniter wire is connected firmly to the
Make sure the igniter wire is connected firmly to the
•
valve ignition device and the electrode.
Make sure the valve orifice is free of any debris, dust
Make sure the valve orifice is free of any debris, dust
•
or grease.
Make sure the valve orifice is aligned inside the front
Make sure the valve orifice is aligned inside the front
•
hole of the burner.
If there is no spark at all, replace the electrode or
If there is no spark at all, replace the electrode or
•
igniter wire.
Note: Turn off the gas at the source while
troubleshooting.
Appendix