Regency IG35-NG Manuel D’Utilisation

Regency IG35 Gas Inbuilt Fireplace

Before operating this appliance, proceed through 
the following check list.

1)  Read and understand these Instructions 

before operating this appliance.

2)  Check to see that all wiring is correct and 

enclosed to prevent possible shock.

3)  Check to ensure there are no gas leaks.

4)  Make sure the glass door is in place. Never 

operate the appliance with the door glass 
removed.

5)  Verify that all fl ueing and the cap is unob-

structed.

6)  Verify log placement.

7)  The unit should never be turned off and on 

again without a minimum of a 60 second 
wait.

8)  When lighting the appliance, the inside of 

the glass may fog up. This will burn off after 
a few minutes of operation.

1)  Plug the power cord into a power outlet.

2)  Press and release the ON/OFF switch once 

to start the unit. The LED will be lit.

3)  After approximately 8 seconds the spark 

ignition system will spark for 8 seconds to 
light the main burner.

4)  If the main burner does not light, repeat step 

2 to restart the unit.

1)  Press the ON/OFF switch once.

2)  The LED will fl ash.

3)  Turn off all electric power to the appliance 

if service is to be performed.

The FIRST FIRE in your heater is part of the 
paint curing process. To ensure that the paint 
is properly cured, it is recommended that you 
burn your fi replace for at least four (4) hours the 
fi rst time you use it with the fan on. 

When  fi rst operated, the unit will release an 
odour caused by the curing of the paint and the 
burning off of any oils remaining from manufac-
turing. Smoke detectors in the house may go off 
at this time. Open a few windows to ventilate 
the room for a couple of hours. The glass may 
require cleaning.

NOTE:  The main burner will always start on 

"HIGH" and resume it's last setting after 
20 seconds of operation.

NOTE: When the glass is cold and the appliance 

is lit, it may cause condensation and fog 
the glass. This condensation is normal 
and will disappear in a few minutes as 
the glass heats up.

DO NOT ATTEMPT TO CLEAN THE 
GLASS WHILE IT IS STILL HOT!

Set the fan speed on the control panel at the top 
rear of the unit to adjust to the desired speed. 

Pressing and releasing the plus (+) FAN button 
will change the fan speed as follows:

OFF -> LOW -> MEDIUM -> HIGH -> OFF, 
etc.

Pressing and releasing the minus (-) FAN button 
will be the reverse of the above.

 
There are six fl ame settings that can be adjusted 
by pressing and releasing the plus (+) and  minus 
(-) FLAME button.

The FLAME setting button is located on the 
control panel at the top rear of the unit.

On/Off Button
If the unit  is switched off, pressing and releasing 
this button once will switch the unit on. The unit 
will resume its last settings.

If the unit is switched on, pressing and releasing 
this button once will switch the unit off.

Flame:
Increase - If the unit is switched on, pressing 
and releasing the fl ame plus (+) button once will 
increase the fl ame height to the next available 
high setting.

Decrease - If the unit is switched on, pressing 
and releasing the fl ame minus (-) button once 
will decrease the fl ame height to the next avail-
able low setting.

Fan:
Increase - If the unit is switched on, pressing 
and releasing the fan plus (+) button once will 
increase the fan speed to the next available 
high setting.

Decrease - If the unit is switched on, pressing 
and releasing the fan minus (-) button once will 
decrease the fan speed to the next available 
low setting.