Avaya 518-456-804 Manuel D’Utilisation
6 Maintaining Your System
Using a PC Card
71
Quick Reference Guide
5
Power up the system:
a
Reconnect the power cord.
CAUTION:
The power cord should hang straight down from the connector, flush
against the plastic case. Do not install the power cord at an angle to
the case or with a loop in it.
against the plastic case. Do not install the power cord at an angle to
the case or with a loop in it.
b
If you have a 5-slot carrier, move the carrier’s On/Off switch to the “On”
position (“—”).
position (“—”).
The LEDs on the processor module (center slot) will alternate red/green
while the upgrade is being performed. When the upgrade is finished, the
LED will appear steady green.
while the upgrade is being performed. When the upgrade is finished, the
LED will appear steady green.
6
Make sure each module has a green LED in the same horizontal area, and
that they all appear steady green. This indicates that each module is
powered up.
that they all appear steady green. This indicates that each module is
powered up.
• If a single light is out, power down the control unit, reseat the module and
power up the control unit.
• If multiple lights are out, power down the control unit, reseat the leftmost
module that has a light out, and power up the control unit.
• If the lights are still out, call for support as instructed on the inside front
cover of this guide.
• PARTNER ACS Release 7.0 provides a firmware upgrade capability
for the 1600 DSL module. If you are performing a firmware upgrade
of this module, see
of this module, see
for a description of how the LEDs appear
during the upgrade.
• PARTNER ACS Release 7.0 provides a firmware upgrade capability
for the 012E module. If you are performing a firmware upgrade of
this module, see
this module, see
for a description of how the LEDs appear during the
upgrade.