Furuno 1622 Manuel D’Utilisation
2
4.
Using the hex bolts, flat washers and spring
washers removed at step 1, fasten the base
to the platform. The torque should be
between 19.6-24.5 N
washers removed at step 1, fasten the base
to the platform. The torque should be
between 19.6-24.5 N
•
m.
Note: Longer hex bolts (M10X25) are
supplied with the installation materials. Use
them instead of the hex bolts removed
earlier if the mounting platform is very thick.
supplied with the installation materials. Use
them instead of the hex bolts removed
earlier if the mounting platform is very thick.
Flat
washer
Antenna base
assy.
assy.
Spring
washer
Platform
Hex bolt
(M10 x 25
or M10 x 20)
(M10 x 25
or M10 x 20)
Transceiver
module
module
5-10
mm
mm
Figure 4 How to fasten the base to platform
5.
Unfasten the cable of the rotation detector
from the cable clamp.
from the cable clamp.
Cable clamp
Rotation detector
Caution
Figure 5 Antenna unit, inside view
Caution: Be careful not to pinch the
rotation detector cable when remounting
the shield plate.
rotation detector cable when remounting
the shield plate.
6.
Unfasten 11 screws to dismount the shield
plate.
plate.
Shield Plate
Discard screw
marked with .
marked with .
Figure 6 Antenna unit, inside view
7. Pass the antenna cable with connector
through the gasket and cable clamp, and
then tighten cable gland.
Be sure the shrink tubing on the antenna
cable is not covered by the gasket.
then tighten cable gland.
Be sure the shrink tubing on the antenna
cable is not covered by the gasket.
Gasket
Cable Gland
Cable Gland
Rubber
Gasket
Gasket
Figure 7 Antenna unit, inside view
8. Referring to Figure 8, fasten the shield
cable to a screw (M4x 10) on the chassis to
ground the unit.
ground the unit.
Connect 9 pin
connector
here (J801).
connector
here (J801).
Connect
shield here.
shield here.
Figure 8 How to connect the antenna cable
to the antenna unit