Furuno 1650DF Manuel D’Utilisation

You will need the following tools:

• Sandpaper (#100)

• Silicone sealant

• Silicone grease

• Do the installation with the boat hauled out of the water.

• Turn off the engine while installing the equipment.

• Install the transducer in the engine room.

Keep the following points in mind when selecting a mounting loca-
tion:

• The mounting location should be where the hull is of single-hull

thickness and is void of air or flotation materials other than solid
fiberglass between the transducer face and the water.

• Do not place the transducer over hull struts or ribes which run

under the hull.

• Avoid a location where the rising angle of the hull exceeds 15

°

, to

minimize the effect of the boat’s rolling.

• You will finalize the mounting location through some trial and

error. The procedure for this is shown later.

50cm

50cm

15cm

15cm

1/3

1/2

Mounting location
for transducer

Center line