Furuno 1834C-BB Manuel D’Utilisation
1-11
12. Pass the cable from the rotation detector through two cable clamps.
Rotation detector
Cable clamps
Cable tie
(Another should
be inside.)
Antenna unit, clamping the rotation detector cable
13. Follow the instructions on the label inside the mounting base to secure the snap assy.
14. Confirm that the rubber gasket is properly positioned and that the triangle mark on the
14. Confirm that the rubber gasket is properly positioned and that the triangle mark on the
radome cover is aligned with the triangle mark on the mounting base, then tighten the
fixing screws for the cover. See the sectional view on page 1-9 for how to position the
rubber gasket.
fixing screws for the cover. See the sectional view on page 1-9 for how to position the
rubber gasket.
Mounting the optional mounting bracket
A mounting bracket for fastening the antenna unit to a mast on a sailboat is optionally
available.
available.
Contents of mounting bracket 2 kit Type: OP03-93, Code No.: 008-445-080
Part Type
Code
No.
Qty
Hex. bolt
M4x12
000-804-725
4
Hex. bolt
M8x20
000-805-707
8
Mounting plate
03-018-9001-0
100-206-740
1
Support plate (1)
03-018-9005-0
100-206-780
1
Support plate (2)
03-018-9006-0
100-206-790
1
Bracket (1)
03-028-9101-0
100-206-810
1
Bracket (2)
03-028-9102-0
100-206-820
1
Fixing plate
03-028-9103-0
100-206-830
2
Assemble the mounting bracket and fasten it to a mast. Fasten the antenna unit to the
bracket. For details, see the figure on the next page.