GE ZGG48N42 Manuel D’Utilisation

27

• Check to see if other burners on the unit operate.

• Remove the grill rack and the stainless steel radiant tray, and watch 

the igniter tip. You should see a spark jump from the tip of the 
igniter when the knob is turned. If there is a spark, then check to 
ensure there is gas supplied to the unit.

• Use a match to light the burner. (See the “To light the grill” section). 

• Visually check the electrode and wire while turning the igniter. 

The only place a spark should appear is at the electrode tip. 
If the electrode or wire leaks voltage, remove and replace.

• Purge the gas line of any air.

• Check the brass orifice for blockage.

• Inspect the igniter tip to make sure it is clean and free from debris. 

Clean the area. Readjust for 1/8

″ gap.

• Check the burner inlet for obstructions.

YELLOW OR ORANGE • Check the air shutter for proper adjustment. 

(See the “Installation Instructions”).

• Placement of the cooking center is important for proper burner

operation. Do not place the cooking center in a dusty area.

• Inspect the fuel hose to ensure it is not bent or kinked.

• Adequate gas supply may not be available. Check to make sure there 

is gas in the LP tank (if included).

• If it is only one burner that appears low, the burner or burner orifice 

may need cleaning.

• The air shutter may need adjustment.

• Preheat the grill for 15 minutes with the lid closed.

• Check for a spark at the igniter.

• Use a match to light the burner.

(on some models)

• Readjust the thermocouple so that it is not bent or kinked, but 

lies flat against the burner.

BUT WILL NOT HOLD • Hold the safety valve button in until the burner remains lit.

FLAME ONCE 
BUTTON IS RELEASED
(on some models)

• The burner may be upside down. Rotate the burner 180° and 

reinstall. Make sure it is secure and level.

The Problem Solver