CDA CW897 Manuel D’Utilisation

Page de 12
Important
Never store inflammable or explosive items and strong corrosive acids or alkalis in the appliance.
This is a household appliance, which is produced in accordance with the national standard. It is intended for food storage 
only, not for storage of blood, medicine and biological products.
To prevent risk of fire, keep the appliance away from petrol or any other inflammables.
To prevent risk of electromagnetic interference or other accidents, do not place a microwave oven on top of the 
refrigerator or use any electric appliance inside the refrigerator.
Do not allow children to play with or near the appliance.
The internal surface of freezer compartment is very cold when the appliance is running. Do not touch the surface 
especially when hands are wet.
Do not splash water onto the appliance. Keep it away from places of high humidity that may have adverse effect on the 
electric insulation performance.
Please remove the door, door seal and shelves before disposal of the old appliance and put them away in a safe place to 
prevent children from being entrapped.
Before first use of the fridge
You must allow the fridge to settle for at least twenty four hours prior to switching the power on.
It is recommended that you clean the interior of the appliance prior to first use, using a solution of bicarbonate of soda 
and warm water and then thoroughly drying the interior.
The fridge may have an odour to it at first use. This will disappear as the appliance cools.
The green power light and the red temperature warning light on the control panel will be lit when you have plugged the 
appliance in to the power supply. Then turn the thermostat dial fully clockwise until the red temperature warning light 
on the control panel goes off.
Approximately two hours after the red light has gone off, turn the thermostat down to the required level.
Please note:
The appliance will work continuously until it comes down to the correct temperature.
If the appliance is switched off, you should allow five minutes before switching it on again to prevent unnecessary damage 
to the compressor.