Vinotemp VT-16TEDS Manuel D’Utilisation

 
 

                   

 

 
 
 

•  Remove any exterior and interior packing material. 

•  Check to be sure the following parts are included: 

o  For 16 Bottle Wine Cellar, 3 slide out shelves. 
o  1 instruction manual. 

•  Before connecting the appliance to the power source, let it stand 

upright for approximately 2 hours. This will reduce the possibility of 
a malfunction in the cooling system from handling during 

transportation. 

•  Place your appliance on a surface that is strong enough to support 

the appliance when it is fully loaded. 

•  To level your appliance, adjust the front legs at the bottom of the 

appliance. 

•  Designed for freestanding installation only, away from direct 

sunlight and sources of heat (stove, heater, radiator, etc.). Direct 

sunlight may affect the acrylic coating and heat sources may 
increase electrical consumption. Several inches clearance is 

required at rear for proper air circulation. 

•  Clean the interior surface with lukewarm water using a soft cloth. 

It is recommended that you install the wine cellar in a place where the 
ambient temperature is between 50-80°F. If the ambient temperature 
is above or below recommended temperature, the performance of the 

unit may be affected. Placing in extreme cold or hot conditions may 
cause interior temperature to fluctuate. The range of 54-66°F may not 

be reached. Not intended for garage or basement installs. The 
temperature may fluctuate depending on whether or not the interior 

light is on or off or whether the bottles are located on the upper/middle 
or lower section. Close the cellar door immediately after putting in any 

items so the inside temperature will not rise dramatically.