Master Bilt BSD Series Manuel D’Utilisation

 

1 

4/07       

 

INSPECTION 

 

When the equipment is received, all items should be carefully checked against the bill of 
lading to insure all crates and cartons have been received. All units should be inspected for 
concealed damage by uncrating the units immediately. If any damage is found, it should be 
reported to the carrier at once, and a claim should be filed with the carrier. This equipment 
has been inspected and tested at the manufacturing facility and has been crated in 
accordance with transportation rules and guidelines. Manufacturer is not responsible for 
freight loss or damage. 
 

If casters are installed, care should be taken when removing the unit from the crate base. 
The unit is heavy and can present a hazard if not handled with care. Remove the unit crate 
and crate base. Discard hardware used to secure the cabinet to the crate base. Ensure that 
at least two persons are available to install the casters. Lay the cabinet on its back to 
create access to the cabinet bottom. Attach the casters to the cabinet base suing the 
factory installed screws as shown below. 
Remove the ¼ x 20 x ¾ screws (4 per 
caster) that are factory installed. Position the 
caster and reinstall. Ensure that the locking 
casters are installed on the front of the 
cabinet. After installation is complete, return 
the cabinet to its upright position. The 
cabinet should set in the upright position for 
at least one hour prior to energizing. This is 
required to allow the refrigeration to settle to 
its normal state. The cabinet should also be 
levelled when it is placed in its permanent 
location.