Samsung GI6FARXXY Manuel D’Utilisation
setting up
_11
01
SETTING
UP
Do not use without the molded end (Bulb)
of the plastic tubing (
of the plastic tubing (
B ).
Tighten the compression nut (
1.
B ) onto the
compression fitting.
Do not over-tighten the compression nut (
Do not over-tighten the compression nut (
B ) .
Turn water on and check for any leakage. If you
2.
find water drops or leakage in the connection
areas, turn off the main water supply. Check
the connections and, if necessary, tighten.
Flush 1 gallon of water through the filter
areas, turn off the main water supply. Check
the connections and, if necessary, tighten.
Flush 1 gallon of water through the filter
3.
before drinking or using the water from the
refrigerator. (Flush approximately 6 minutes.)
To flush, press a large glass or cup against the
water dispenser lever. Fill the glass, empty it
into the kitchen sink after it is filled, and then
repeat.
After you turn on the refrigerator, let the ice
refrigerator. (Flush approximately 6 minutes.)
To flush, press a large glass or cup against the
water dispenser lever. Fill the glass, empty it
into the kitchen sink after it is filled, and then
repeat.
After you turn on the refrigerator, let the ice
4.
maker make ice for 1 to 2 days. Over that
period of time, throw out the first 1 or 2
buckets of ice the freezer makes to ensure all
impurities have been removed from the water
line.
period of time, throw out the first 1 or 2
buckets of ice the freezer makes to ensure all
impurities have been removed from the water
line.
Only connect the water line to a drinkable
water source.
water source.
If you have to repair or disassemble the water line,
cut off 1/4“ of the plastic tubing to make sure you
get a snug, leak-free connection.
cut off 1/4“ of the plastic tubing to make sure you
get a snug, leak-free connection.
COMPLETING ThE SET UP
Now that you have your new refrigerator installed
in place, you are ready to set up and enjoy the
features and functions of the appliance.
By completing the following steps, your refrigerator
should be fully operational.
in place, you are ready to set up and enjoy the
features and functions of the appliance.
By completing the following steps, your refrigerator
should be fully operational.
Make sure your refrigerator is in an appropriate
1.
location with reasonable clearance between it
and the wall. Refer to installation instructions in
this manual.
Once the refrigerator is plugged in, make sure
and the wall. Refer to installation instructions in
this manual.
Once the refrigerator is plugged in, make sure
2.
the interior light comes on when you open the
doors.
Set the Temperature control to the coldest
doors.
Set the Temperature control to the coldest
3.
temperature and wait for an hour. The freezer
will get slightly chilled and the motor will run
smoothly. Reset the refrigerator and freezer to
the temperatures you want.
After you plug the refrigerator in, it will
will get slightly chilled and the motor will run
smoothly. Reset the refrigerator and freezer to
the temperatures you want.
After you plug the refrigerator in, it will
4.
take a few hours to reach the appropriate
temperature. You can store food and drinks
in the refrigerator after the temperature is
sufficiently cool.
temperature. You can store food and drinks
in the refrigerator after the temperature is
sufficiently cool.
CAUTION
DA68-02601B(EN+ES+FR)-0.0.indb 11
2012.3.29 9:28:42 AM