Samsung DA99-01278C Manuel D’Utilisation

Page de 32
28
INSTALLING OF THE WATER DISPENSER LINE
Connecting to water supply line 
Connect the water line to the refrigerator
Check the water supply line
- Shut off the main water supply line and turn the Ice
maker to  the off position.
- Locate the nearest cold drinking water line.
- Follow the instructions in the ice maker installation kit.
1. Cold Water line
2. Pipe Clamp.
3.Copper (or Plastic) line
4.Compression Nut
5.Compression Sleeve
6.Shut Off Valve
7.Packing Nut.
Compression Nut
Compression fitting
Sleeve
Compression Nut
Ferrule
Ferrule
-  Slip the compression nut and plastic ferrule   
through the plastic tube.
-  After inserting the sleeve, tighten the compression
nut onto 1/4” compression fitting(union).
Waterline must be connected to drinkable water only
NOTE
Do not overtighten the compression nut.
NOTE
-  Slip  the compression ferrule and nut on copper (or
plastic) tubing as shown.
Tighten the comperssion nut onto the compression
fitting(union).
-  Turn water on and check for any leakege.
Connect the water pipe with coupler and tap.
- Close the main water tap.
- Connect coupler “A” to the tap.
- Every join should be protected with sealing tape.
Note:
If the coupler does not fit on the current tap, go
the nearest authorised service dealer and purchase
the right couplers fittings.
WARRANTY INFORMATION
This water line installation is not covered by the 
refrigerator or ice maker manufacturer's warranty.
Follow these instructions carefully to minimise the risk 
of expensive water damage.
TAP
COUPLER “A”
The water line must be connect-
ed to the cold water pipe.
If it is connected to the hot
water pipe, it may cause the puri-
fier to malfunction.
CAUTION