Samsung RFG238AA Manuel D’Utilisation

Setting Up

 

01 
s

E

ttin

G 

u

P

 

sEttinG uP tHE REFRiGERAtoR

Now that you have your new refrigerator installed in place, you are ready to set up and enjoy the features and 
functions of the appliance. By completing the following steps, your Refrigerator should be fully operational.

1.  Place the refrigerator in an appropriate location with reasonable clearance between the walls and the 

refrigerator. 

    Refer to installation instructions in this manual. (page 9, Selecting the best location for the refrigerator)
2. Once the refrigerator is plugged in, make sure the interior light comes on when you open the doors.
3.  Set the Temperature control to the coldest temperature and wait for an hour. The freezer will get slightly 

chilled and the motor will run smoothly.

4.  After powering the refrigerator, it will take a few hours to reach the appropriate temperature. You can 

store food and drinks in the refrigerator after the temperature is sufficiently low.

Check the accessories listed below.

Water filter

Hex wrench

Compression fitting

Compression nut

Fastener

Disassemble the refrigerator doors

1.   With the door opened, remove the hinge top table ( 

 )

with a flat-blade screwdriver, and close the door.

     Remove the 3 screws holding down the top table
     ( 

 ) and remove it.

Disassemble the refrigerator doors

Be careful not to drop and scratch the doors while 
removing the doors.

Required Tools(Not provided)

Philips screwdriver(+)

Flat-blade screwdriver(-)

Socket wrench (7/16”)

Pliers

Allen wrench(3/16”)

REMoVinG tHE REFRiGERAtoR DooRs

Some installations require door removal to transport the refrigerator to its final location.
Do not remove the door/drawer if it is not needed. Before removing the door/drawer, make sure you read 
following items.

•   Be careful not to drop, damage or scratch the door/drawer while removing them.
•   Be careful not to get injured while removing the door/drawer.
•   Reattach the door/drawer properly to avoid: 
    - Moisture from air leakage.
    - Uneven door alignment.
    - Wasting energy due to improper door seal.

Disconnect power to the refrigerator before removing the door or drawer.