Samsung RFG29PHDRS Manuel D’Utilisation

 

setting up

ASSEMBLE THE FREEZER DRAWER

To reattach the drawer after you have moved the 

fridge to its final location, assemble parts in reverse 

order.

ADJUSTING THE LEVEL

Make sure the refrigerator is level so that you can 

make final adjustments. Use a level to test if the 

refrigerator is level both side to side and back to front. 

If the refrigerator is not level, it will not be possible 

to get the doors perfectly even, which may cause 

moisture condensation and increased energy bills. 

Below is an example of how to level the refrigerator if 

the left side of the refrigerator is lower than the right 

side.

1.   Open the freezer drawer 

and remove the lower 

basket. (See to page 7)

2.   Remove the two screws       

( 

1 ) attached to the cover 

leg front ( 

2 ) with a Philips 

screwdriver (+). 

3.   Remove  the  cover  leg  front        

( 

2 ) by lifting the bottom 

part of the cover leg front 

up and pulling it out.

4.   Insert a flat-blade screwdriver (-) into a notch on the 

left control lever, and turn it count clockwise to level 

the refrigerator. (You turn the lever clockwise to lower 

the refrigerator and counterclockwise to raise it.)

Both control levers must be touching the floor 

to avoid possible personal injury or property 

damage because of tipping.

If the right side is lower, perform the same 

procedure, but with the right control lever.
It is difficult to remove the cover leg front from the 

refrigerator, so we do not recommend making 

small adjustments with the control lever. Instead, 

refer to the next page for the best way to make 

minor adjustments to the doors.

MAKING MINOR ADJUSTMENTS 
BETWEEN DOORS

Remember, a leveled refrigerator is necessary for 
getting the doors perfectly even. If you need help, 
review the previous section on leveling the refrigerator.

The left door is fixed. To make minor adjustments 
between doors, adjust only the right door.

1.  Pull out the freezer drawer ( 1 ), then you can see 

the lower hinge ( 

2 ).

2.  Insert the supplied allen wrench(3/16”) ( 3 ) into the 

shaft ( 

4 ) of the lower hinge.

3.  Please adjust the height by turning the hex wrench     

( 

3 ) clockwise (

DOWN

) or counter-clockwise (

UP

).

When you turn the hex wrench counter-
clockwise(

), the door will move up.

1.   After adjusting the doors, insert the supplied 

fastener ( 

6 ) using a pliers ( 5 ) in the gap between 

the hinge-grommet ( 

7 ) and the lower hinge                 

( 

8 ). The number of fasteners you’ll need to insert 

depends on the gap.

2 fastener are enclosed with the refrigerator.
The thickness of each fastener is 0.04”.

flat-blade screwdriver(-) Control Lever

3

1

2

3

4

Adjustment 
part

Fixed part

CAUTION

2

1

DA68-02488A-09.indb   8

13. 4. 25.   �� 2:08