Samsung RF4287HA Manuel D’Utilisation

 

setting up

cHEcKing tHE wAtER DiSPEnSER LinE

A water dispenser is one of the helpful features on your new refrigerator. To help promote better
health, the water filter removes unwanted particles from your water. However, it does not sterilize or
destroy microorganisms. You may need to purchase a water purifying system to do that.

In order for the ice maker to operate properly, a water pressure of 20~125 psi is required.
Under normal conditions, a 170 cc (5.75 oz.) cup can be filled in 10 seconds.

If the refrigerator is installed in an area with low water pressure (below 20psi), you can install a booster pump to
compensate for the low pressure.

Make sure the water storage tank inside the refrigerator is properly filled. To do this, press the water dispenser
lever until the water runs from the water outlet.

Water line installation kits are available at extra cost from your dealer. We recommend using a water line 
installation kit that contains copper tubing and ¼” compression nut.

1.  First, shut off the main water supply.

2.  Locate the nearest cold water drinking line and install the 

pipe clamp and shut off valve.

3.  Connect the water line installation kit to 

shut off valve.

After connecting the water supply with 
water filter, turn on water supply and 
Flush 1 gallons through filter before using 
(flush approximately 6 minutes).
If water drop or leakage is found on the 
connection area, turn off the main water 
supply.
Check it and, if necessary, tighten it more.

AW3.indd   22

2010.3.4   2:33:51 PM