Multiquip MQ62TDD Manuel D’Utilisation
MQ62TDD TRASH PUMP • OPERATION AND PARTS MANUAL — REV. #0 (07/30/09) — PAGE 21
CONTROL BOX COMPONENTS
Figures 6 and 6A illustrate the location of the basic
components for the control box. The function of each
component is described below:
components for the control box. The function of each
component is described below:
1. Ignition Switch – Used to start and stop the engine
2. Reset Switch – When the engine has been shut-down
due to a malfunction, the RED reset pushbutton must
be pressed prior to starting the engine again. In
addition, the fault that caused the engine to shut-down
must be corrected before starting.
be pressed prior to starting the engine again. In
addition, the fault that caused the engine to shut-down
must be corrected before starting.
3. Oil Pressure Status Indicator – When lit indicates
that the oil pressure is not within specified limits. This
condition will cause the engine to shutdown.
condition will cause the engine to shutdown.
Figure 6. Control Box Components (Old Style)
0
P
I
II
III
NOTICE
RED BUTTON MUST
BE DEPRESSED FOR
ENGINE START UP
MURPHY
TULSA
TAT
TLETALE
TM
RE
SET BEFORE
STARTING
BUTTON OUT
IN
DIC
ATES SHUTDO
W
N
C
O
N
DIT
IONS
WERE P
RE
SE
N
T
1
2
3
4
5
Figure 6A. Control Box Components (New Style)
AUX
1
AUX
2
OFF
RUN
HOURS
1
3
4
5
6
7
START
FUSE LOCATED INSIDE PANEL
4. Oil Temperature Status Indicator – When lit indicates
that the oil temperature has exceeded its limit. This
condition will cause the engine to shutdown.
condition will cause the engine to shutdown.
5. Charge Indicator – When lit indicates that the charging
system is not working properly. This condition will cause
the engine to shutdown.
the engine to shutdown.
6. Preheat Status Indicator – When lit indicates the
preheat system is in process. When light extinguishes,
the preheat period is complete and the engine may be
cranked.
the preheat period is complete and the engine may be
cranked.
7. Hour meter – Indicates the number of hours the
machine has been in use.