Jenn-Air W10274308F Manuel D’Utilisation

Page de 28
10
When the charcoal filter has been excluded, the charcoal filter 
alarm is disabled.
The inclusion or exclusion of the charcoal filter must be 
selected while the lights and the fan motor are Off.
Heat Sensor
The control is equipped with a heat sensor that will turn on the 
blower to the highest speed if excessive heat occurs around the 
control area.
If the blower is On or Off, the blower will automatically set to 
the highest speed. “Auto” will appear in the display to 
indicate that the heat sensor has detected excessive heat.
When the blower is operating due to excessive heat detected 
by the heat sensor, the blower speed cannot be decreased.
When the temperature level on the hood drops to normal, the 
blower will return to its setting before the excessive heat was 
sensed.
Light
To operate the light:
1. Press the Light button to turn the light on to high.
2. Press the Light button again to turn the light to low.
3. Press the Light button a third time to turn the light off.
Timer 
The timer can be set from 1 to 60 minutes. The default timer 
setting is 10 minutes.
To use the timer:
1. Press the Timer button to enter the timer mode. After 
5 seconds the default time will be automatically selected.
2. Press the POWER DECREASE and POWER INCREASE 
buttons while the display is flashing (5 seconds) to adjust to 
the desired time. Pressing the timer button again or waiting 
5 seconds after selecting the desired time will start the timer 
countdown.
3. The timer can be canceled at any time by pressing the Timer 
button again. 
NOTE: During the timer setup, the Power Decrease and Power 
Increase buttons are dedicated to the timer. After the timer starts, 
the Power Decrease and Power Increase buttons can be used for 
other functions.
Fan Speed Buttons
Power Increase/On
This button is used to turn the fan On or increase the fan speed.
The fan will turn On if the Power Increase button is pressed 
and the hood was Off.
An audible tone will sound when the fan reaches its highest 
speed.
Power Decrease/Off
This button is used to turn the fan Off or to decrease the fan 
speed.
RANGE HOOD CARE
Cleaning
IMPORTANT: Clean the hood and grease filters frequently 
according to the following instructions. Replace grease filters 
before operating hood.
Be sure lights are cool before cleaning the hood.
Exterior Surfaces
Clean the range hood with a mild detergent and soft cloth. To 
avoid damage to the exterior surface, do not use abrasive 
cleanser or steel-wool pads.
Metal Grease Filters
The filters should be washed frequently. Place metal filters in 
dishwasher or hot detergent solution to clean.
Let filter dry thoroughly before replacing it.
To Remove Metal Grease Filters
1. Turn off fan and lights. Check that halogen lamp is cool.
2. Remove the filter holder frame and grease filter using a flat-
blade screwdriver to turn the grease filter release screws 90° 
counterclockwise.
A. Grease filter release screw
B. Filter holder frame
C. Grease filter
A
C
B