Cornelius KM250 Fascicule

1

630460040

9/16/97

Rev A

IMI CORNELIUS INC.
One Cornelius Place

Anoka. MN 55303-6234
Telephone (800) 238–3600
Facsimile (612) 422–3246

These “K” style kits apply to the following ice makers and are for use with DF/ED 200/250 dispensers:

Ice Maker

Size

Hoshizaki  KM250/450/500/630/650

22

I

1

630000310

Lid Assembly, “K” Style

1

2

15303

Bracket

1

3

50904

RTV, Clear, 732, 3 oz. Tube

1

4

630000311

Cover, RH Assembly

1

5

70217

#8 Sheet Metal Screw

6

6

90221

Label, Disconnect Before Cleaning

1

7

70188

Thumb Screw #8-32 

 1/2

I

1

8

630460040

Installation Instruction

1

9

22127

Bracket, LS Mounting

1

1. Set Ice maker lid on the top of the dispenser and position it flush with the back and sides of the dispenser.

2. Using the slotted holes in the lid as a template, drill four (4) .140

I

 diameter holes at the bottom of the slots

(see detail A). Use extreme care not to drill into the hopper. Fasten the lid to the dispenser with four (4) #8
sheet metal screws, two on each side.

3. Seal the ice maker to the top of the dispenser as follows:

A.

Apply beads of RTV around the opening in the lid and inside the perimeter of the ice maker outline so
that the ice maker will set on the RTV.

B.

Set the ice maker onto the lid and position it as required.

C.

Wipe away any excess RTV.

4. Remove the two rear screws (only) installed in step 2. Use those screws to install the mounting brackets

(item 2 and/or item 9). Drill 9/64

I

 diameter holes into the ice maker cabinet using the bracket as a tem-

plate. Use extreme caution not to drill into any ice maker components (condenser, tubing, etc.). Secure the
brackets using the screws provided.

5. Follow the ice maker manufacturers instruction to complete the installation of the ice maker including the

bin thermostat if so equipped or required.