Sharp R-90GC Manuel D’Utilisation

A37159,SEC R90GC O/M

TINSEA986WRRZ-D31 SEC R90GC

C L E A N I N G   A N D   C A R E

Disconnect the power cord before cleaning or
leave the door open to inactivate the oven dur-
ing cleaning.

The outside surface is precoated metal and plas-
tic. Clean the outside with mild soap and water;
rinse and dry with a soft cloth. Do not use any
type of household or abrasive cleaner.

Wipe the window on both sides with a damp cloth
to remove any spills or spatters. Metal parts will
be easier to maintain if wiped frequently with a
damp cloth. Avoid the use of spray and other
harsh cleaners as they may stain, streak or dull
the door surface.

The exterior should be wiped often with a damp
cloth and polished with a soft dry cloth to main-
tain its beauty. There are also a variety of prod-
ucts designed especially for cleaning and shin-
ing the stainless exterior of the oven. We recom-
mend that the cleaner be applied to a soft cloth
and then carefully used on the stainless exterior
rather than sprayed directly on to it. Follow pack-
age directions carefully.

Wipe the panel with a cloth dampened slightly with
water only. Dry with a soft cloth. Do not scrub or
use any sort of chemical cleaners. Close door and
touch STOP/CLEAR.

- after microwave cooking.

Cleaning is easy because no heat is generated to
the interior surfaces; therefore, there is no baking
and setting of spills or spattering. To clean the inte-
rior surfaces, wipe with a soft cloth and warm wa-
ter. DO NOT USE ABRASIVE OR HARSH CLEAN-
ERS OR SCOURING PADS. For heavier soil, use
mild soap; rinse thoroughly with hot water. Do not
use any chemical oven cleaners.
You may remove any lingering interior odor by us-
ing the Refresh Cycle on page 30.

- after manual/automatic speed or

convection cooking.

Spatters may occur because of moisture and
grease. Wash immediately after use with hot, soapy
water. Rinse and polish dry. Harder to remove spat-
ters may occur if oven is not thoroughly cleaned or
if there is long time/high temperature cooking. Do
not use any chemical oven cleaners.

After cleaning the interior thoroughly, residual grease
may be removed from the interior ducts and heat-
ers by simply operating the oven with Refresh Cycle
on page 30. Ventilate the room if necessary.

The waveguide cover is made from mica so re-
quires special care. Keep the waveguide cover
clean to assure good oven performance. Care-
fully wipe with a damp cloth any food spatters from
the surface of the cover immediately after they
occur. Built-up splashes may overheat and cause
smoke or possibly catch fire. Do not remove the
waveguide cover.

The turntable, turntable support, racks and splash
guard can be removed for easy cleaning. Wash
them in mild, sudsy water; for stubborn stains use
a mild cleanser and a non-abrasive scouring
sponge. They are also dishwasher-proof. Use
upper rack of dishwasher for turntable support.

Foods with high acidity, such as tomatoes or lem-
ons, may cause the porcelain enamel turntable
and splash guard to discolor. Do not cook highly
acidic foods directly on the turntable; if spills oc-
cur, wipe up immediately.

After cooking, always clean the turntable support,
especially around the rollers. These must be free
from food splashes and grease. Built-up splashes
or grease may overheat and cause arcing, begin
to smoke or catch fire.

roller

SEC R90GC O/M,P30-32

03.5.12, 6:02 PM

31