Sharp R-1405T Manuel D’Utilisation

U N P A C K I N G A N D I N S T A L L A T I O N I N S T R U C T I O N S

11 MOUNTING OVEN TO THE WALL

Two people are recommended to attach the Microwave Oven/Hood to the Mounting Plate.
1. Thread the Power Supply Cord through the hole made in the bottom of the top cabinet.

2. Lift and tilt the oven forward. Hook the back bottom of the oven to the bottom of the Mounting Plate. See

Figure 21.

3. Lift the front of the oven up to the bottom of the cabinet. Keep the Power Supply Cord tight to avoid interference

with mounting the oven flush with the bottom of the cabinet.

4. Use the two Top Cabinet Screws 3 and two Flat Washers 5, supplied in the INSTALLATION HARDWARE, to

attach the unit to the top cabinet. Tighten until the top of the oven is tight against the bottom of the cabinet. See
Figure 22.

5. Attach the two Bottom Plate Screws saved from section

7 PREPARATION OF THE OVEN. See Figure 23.

6. Install the two Grease Filters 9. See Figure 23.

Figure 22

Figure 23

Figure 21

CHECKLIST FOR INSTALLATION

1. Make sure the unit has been installed according to all of the Installation Instructions and the Wall and Top Cabinet

Templates.

2. Plug in the power cord.
3. Keep the Operation Manual and Installation Instructions.

Bottom Plate

Screws

318-3_1405,06 manual.indd 13

5/14/07 2:14:01 PM