Hamilton Beach Tango Series Manuel D’Utilisation

Troubleshooting Guide

Replacement Parts

Problem . . . 

Solution . . .

Blender fails to start
or stops while it is
running and cannot
be restarted

• Check to see if unit is securely plugged into an electric outlet.

• Check to see if the fuse for the electric outlet has blown or if a circuit breaker 

has tripped.

Maintenance

Unplug the blender and remove the container from the base, and then inspect the
container and cutter unit assembly for wear, nicks, and broken or loose blades. Replace if
necessary. If the blades are loose, discontinue use immediately and replace the blades. 
Do not attempt to repair or tighten the cutter assembly. See “Replacement Parts” below. 

Unplug the blender, and then inspect the power cord insulation and power plug for cracks.
Refer to “Requesting Assistance or Service” for repair or replacement.

Replace the container and cutter assembly at least once a year. 
See “Replacement Parts” below.

1G91300

1 container

6126-91300

1G91300

Cutter assembly

99200

Model

Part Description

Part Number

Inspect the blender and its various parts and replace as follows: 

Daily

Weekly

Yearly

Ingredients will not mix
properly

• Check to see if enough liquid has been added to the ingredients. Mixture should

be fluid and free-running at all times.

• Solid pieces are too large. Pieces should not exceed 1" cubes.

• Container is too full. Do not fill past highest graduation marking.

• Cutter unit blades are not sharp or are damaged. Inspect 

container and cutter assembly daily. Replace container and 
cutter assembly at least every 12 months or sooner if cutter assembly appears
worn or damaged.

• Check to see if cutter assembly is installed properly.

• Select speed to create a fluid blend.

Refer to “Requesting Assistance or Service” to order parts below.

261 Yadkin Road

Southern Pines, NC 28387