GE Monogram GFK-1115 Manuel D’Utilisation

PCS is delivered on two 3½-inch disks in 2DD (720K) format and on one 5¼-inch disk in 2S/HD
(1.2M) format. The diskette(s) you use to install the PCS depends on your PC configuration.

PANELWARE Configuration Software
(includes cable assembly)

IC641SWP950

Before starting the software installation, make sure the following requirements are met:

■ 

Complete IBM PC compatibility (processor types: 80286 and higher)

■ 

IBM compatible monochrome or color adapter

■ 

One 3½ inch (720 Kbyte) or 5¼ inch (1.2 Mbyte) floppy disk drive

■ 

For the installation, approximately 3 Mbytes must be free on the hard disk.

■ 

640 KB RAM, of which at least 512 KB must be available. Memory-resident programs
should be removed if necessary to free up the RAM.

■ 

Minimum 1 serial interface (COM1 or COM2)

■ 

MS-DOS version 3.30 or higher

■ 

The CONFIG.SYS file settings for FILES and BUFFERS must be set to a minimum of:
FILES=40; BUFFERS=10.

PCS can be executed in a DOS box under Windows 3.1 only in offline mode. To
either download or upload a project to/from a Panel, you must exit Windows and
run PCS from the DOS prompt.