Hobart LX18 Manuel D’Utilisation

– 28 –

Machine fills too high or

1. Machine not level — see LEVELING in this manual.

leaks from door.

2. Fill solenoid valve leaking — turn the dishwasher OFF; if water

continues to come in (through the rear fill air gap on LX18

   Machine won't drain.

models or rinse arms of LX30 and LX40 models), call your local

   (Display shows "E5" on

Hobart Service Office.

LX18 and LX30 models,

3. Drain pipes restricted — check dishwasher drain line for kinks;

or "PRBLM DR2" on LX40.)

ensure proper drain rate is allowed from plumbing.

4. Turn machine OFF.  Wait several seconds, then turn back ON.

Repeat this procedure twice if necessary.   If problem persists,
contact your local Hobart Service Office.

Some  water  occasionally

This is normal due to expansion of water being heated in the booster

drips out of rinse arms

tank.

(LX30 and LX40 models) or

   from the water inlet on the

back wall (LX18 models)
when machine is idle
("H" dishwashers only.)

Machine displays "E6" on

Contact your local Hobart Service Office.

LX18 and LX30 models
or "OP J1" on LX40 models.

Machine drains water

This is normal operation on LX18 models if water temperature is

after pressing WASH.

too low (see page 14).

Machine lights up wrench

Contact your local Hobart Service Office.

and flashes "P1", P2", or
"P3" on LX18 and LX30
models), or "PROB1",

   "PROB2", or "PROB3" on

LX40 models.

Machine displays "E7" on

1. Clean water sensors inside tank.

LX30 model or "CLEAN

2. Contact your local Hobart Service Office.

PROBE" on LX40 model.

Contact your local Hobart-authorized service office for any repairs or adjustments needed on this
equipment.