Multiquip GB2000 Manuel D’Utilisation

1.  Remove the adapter plate kit hardware from its 

container.

2.  Before proceeding make sure the light tower mast is 

in the stow position (down) and the cradle lock/release 

pin has been inserted and the mast is locked.

3.  Attach the lamp adapter plate to the T-Bar as shown 

in Figure 7. Align adapter plate so that adapter spacer 

notch fits over screw on T-Bar. Please pay close 

attention to the orientation of the 2 support brackets. 

4.  Mount the flat end of both support brackets flush 

against the T-Bar with the 

low  end of each bracket 

facing inward toward the mast. The 

raised end of each 

bracket should be facing outward.

Please pay close attention to the orientation of the 2 

support brackets. Each bracket has a high and low side. 

The low side of the bracket should be facing inwards 

towards the mast.

5.  Next, insert a bolt (4) and flat washer (4) thru the 

mounting holes on the adapter plate as shown in Figure 

7. Again, pay close attention on which set of holes to 

insert the bolt thru. 

Bolt number 2 must be oriented 

so that it passes between receptacles J1 and J2 on 

the T-Bar.

6.  Secure the adapter plate to the T-Bar using the supplied 

flat washer (4), lock washer (4) and nut (4). Make sure 

the adapter plate is level (use a bubble level) and both 

brackets are straight (vertical), not slanted before 

tightening