Fujitsu CM25-00322-1E Manuel D’Utilisation
![Fujitsu](https://files.manualsbrain.com/attachments/6c4642b33d2edbd09f94719c20a133aa0e862902/common/fit/150/50/80a45702a21fefb1823bce6851e87db450dccf7792cb572ebc8a90330a68/brand_logo.png)
275
CHAPTER 4 MENUS
4.7.2.4
Setup Wizard
This section explains how to operate the debugger's Setup Wizard.
■ Setup Wizard operation procedure
1. Select [Setup Name] from [Debugger Startup Selection], then click the [OK] button.
The check dialog box opens.
2. Click the [OK] button.
Debugger’s Setup Wizard is started.
3. Click the [Next] button.
4. Select a debugger type, then click the [Next] button.
Setting of the subsequent items depends on the debugger’s type.
To reset an item, click the [Return] button.
The immediately preceding setup screen is redisplayed.
■ Procedure when the emulator (MB2141) is selected
1.
Select the ICE type.
2.
Click the [Next] button.
3.
Select [RS232C] or [LAN] as the device type.
When [RS232C] is selected, set a port and baud rate.
When [LAN] is selected, set a host name.
4.
Click the [Next] button.
5.
Set whether or not to automatically load the monitor program at debugging start.
6.
Click the [Next] button.
7.
Set whether or not to load the target file automatically during debugging.
8.
Specify the batch files used before and after load as required.
Clicking the [Refer] button to the right of each input field enables batch file selection.
9.
Click the [Next] button.
10. Select the item to be set in the setup file.
When [Specify] is selected, click the [Setup] button to open the item selection dialog box, select the
item to be set from the dialog box, then click the [OK] button.
11. Click the [Next] button.
12. Click the [Complete] button.
Emulator (MB2141) setup has been just completed.