Burris LH 4 Manuel D’Utilisation

 

This guide describes the procedure for converting the HP NetServer LH 3, LH 4, 
LH 3000, and LH 6000 (pedestal configuration) to the HP NetServer LH 3r, 
LH 4r, LH 3000r, or LH 6000r (rack-optimized configuration). 

For details of installing the NetServer into the rack enclosure, refer to the 
following: 

•

  For a NetServer in an HP rack: your NetServer's user guide or 

installation guide 

•

  For a NetServer in a Compaq rack: HP NetServer LH 3r, LH 4r, 

®

 4000/7000 Racks 

For cabling details, refer to the appropriate one of the following: 

•

  Rack Cabling Reference for the HP NetServer LH 3r  

•

  Rack Cabling Reference for the HP NetServer LH 4r 

•

  Rack Cabling Reference for the HP NetServer LH 3000r 

•

  Rack Cabling Reference for the HP NetServer LH 6000r 

Briefly, the conversion and installation include these general steps: 

 

1.  Gather the tools and documentation needed to perform the conversion and 

installation.  

 

2.  Power down the NetServer and disconnect power cord(s) and cables. 

 

3.  Remove the front bezel, rack rail cover, hard disk drives, and power supply 

modules. 

 

4.  Move the NetServer to a bench area, and position it on its side (Cover 1 up, 

and Cover 3 down). Remove the casters from the NetServer, and install any 
additional memory or accessory boards.  Attach the lifting handles to the 
NetServer.