Enterasys Networks ELS10-27TX Manuel D’Utilisation
Enhancements to LCM Commands
2-5
2.5 LCM COMMANDS
The following is a list of commands that were modified for this release:
•
Enable Command
•
Route Command
•
Port Command
•
Switch Command
•
Trap Control Command
•
VLAN Command
Commands are listed alphabetically in this chapter.
2.5.1 Enable Command (Address Limit)
The address limit parameter was added to the enable command. If you set a limit
on a port, the number of end user devices that can have connectivity will be
limited. This is done by limiting the number of MAC addresses that can be
learned on that port.
on a port, the number of end user devices that can have connectivity will be
limited. This is done by limiting the number of MAC addresses that can be
learned on that port.
The format is:
enable [PORT-RANGE [RIP] [TransmitPacing] [ADDRESS_LIMIT]]
The default is “no limit” to the number of addresses that can be learned on a port.
If you set the limit to zero, you allow unlimited access. If you enable a port
without specifying an address limit, you remove the limit that was in effect.
If you set the limit to zero, you allow unlimited access. If you enable a port
without specifying an address limit, you remove the limit that was in effect.