3com 4500 PWR 26-PORT Manuel D’Utilisation
RIP Configuration Commands
163
[4500-Vlan-interface1]rip version 2 broadcast
rip work
Syntax
rip work
undo rip work
View
Interface View
Parameter
None
Description
Use the
rip work
command to enable the RIP on an interface. This is the default.
Use the
undo rip work
command to disable RIP on an interface.
This command is used in conjunction with the
rip input
,
rip output
and
network
commands. Refer to the descriptions of these commands for details.
Related commands:
network
,
rip input
,
rip output
.
Example
To disable the running of RIP on interface Vlan-interface 1, enter the following:
<4500>system-view
System View: return to User View with Ctrl+Z.
[4500]interface Vlan-interface 1
[4500-Vlan-interface1]undo rip work
summary
Syntax
summary
undo summary
View
RIP view
Parameter
None
Description
Use the
summary
command to activate RIP-2 automatic route summarization. This
is the default.
Use the
undo summary
command to disable RIP-2 automatic route summarization.
Route aggregation can be performed to reduce the routing traffic on the network
as well as to reduce the size of the routing table. RIP-1 does not support subnet
masks. Forwarding subnetted routes may cause ambiguity. Networks that use
RIP-1 should always use the natural mask. Therefore, RIP-1 uses route
as well as to reduce the size of the routing table. RIP-1 does not support subnet
masks. Forwarding subnetted routes may cause ambiguity. Networks that use
RIP-1 should always use the natural mask. Therefore, RIP-1 uses route