3com 4500 PWR 26-PORT Manuel D’Utilisation

C

HAPTER

 1: U

SING

 S

YSTEM

 A

CCESS

 C

OMMANDS

Use the 

 command to configure the priority level 

assigned to any command within a selected view.

The command levels are, from lowest to highest:

■

 – Visit

■

 – Monitoring

■

 – System

■

 – Management

When the user logs into the Switch, the commands used depends on the user level 
settings and the command level settings on the user interface. The two types of 
settings may differ as follows:

■

If AAA/RADIUS authentication is used, the commands the user can access are 
determined by the user level settings. For example, if a user is set to level 3 and 
the command level on the VTY 0 user interface is level 1, the user can only user 
the commands of level 3 or lower when logging into the Switch from the VTY 
interface.

■

If RSA public key authentication is used, the commands the user can access are 
determined by the command level settings on the user interface.

By default:

■

ping, tracert, and telnet are at level 0

■

display and debugging are at level 1 

■

all configuration commands are at system level 2 

■

FTP, XMODEM, TFTP and commands for file system operations are at level 3

Use the 

 command to restore the default priority 

to a command.

To configure the precedence of the command ‘interface’ as 0, enter the following:

<4500>system-view

System View: return to User View with Ctrl+Z.

[4500]command-privilege level 0 view system interface

User interface view

 – Sets the data bits to 7.