3com 4500 PWR 26-PORT Manuel D’Utilisation

C

HAPTER

 12: U

SING

 S

YSTEM

 M

ANAGEMENT

 C

OMMANDS

Use the 

 command to enable the device to send Trap 

message. Use the 

 command to disable Trap 

message sending.

By default, Trap message sending is disabled.

The 

 command and the 

 

command should be used at the same time. The 

 

command specifies which hosts can receive Trap message. To send Trap messages, 
at least one 

 command should be configured.

Enable to send the trap packet of SNMP authentication failure to 

. The 

community name is 

. 

<SW4500>system-view

System View: return to User View with Ctrl+Z.

[SW4500]snmp-agent trap enable standard authentication

[SW4500]snmp-agent target-host trap address udp-domain 10.1.1.1 

[SW4500]

System view

 Specify the timeouts, ranging from 1 to 2592000 seconds.  By default, 

the timeout interval is 120 seconds.

Use the 

 command to set the timeout of Trap packets. Use 

the 

 command to restore the default value. 

The set timeout of Trap packet is represented by

. If time exceeds 

, this Trap packet will be discarded.

For the related commands, see 

, 

.

Configure the timeout interval of Trap packet as 60 seconds.

<SW4500>system-view

System View: return to User View with Ctrl+Z.

[SW4500]snmp-agent trap life 60

[SW4500]