Q-Logic 59226-00 B Manuel D’Utilisation

A – Command Line Interface

Set Config Command

A-40

59226-00 B

S

Sets switch, port, port threshold alarm, and zoning configuration parameters. The 
changes you make with this command are not retained when you reset or power 
cycle the switch unless you save them using the Config Save command. Refer to 
the 

.

Admin session and a Config Edit session

port [port_number]
ports [port_number]
switch
threshold
zoning

Initiates an edit session in which to change configuration parameters for the port 
number given by [port_number]. If you omit [port_number], the system begins with 
port 0 and proceeds in order through the last port. For each parameter, enter a 
new value or press the Enter key to accept the current value shown in brackets. 
Enter “q” to end the configuration for one port, or “qq” to end the configuration for 
all ports. 

 describes the port parameters.

Initiates an editing session in which to change configuration parameters for all 
ports based on the configuration for the port given by [port_number]. If you omit 
[port_number], port 0 is used. For each parameter, enter a new value or press the 
Enter key to accept the current value shown in brackets. Enter “q” to end the 
configuration. 

 describes the port parameters.

AdminState

Port administrative state:

„ Online – Activates and prepares the port to send 

data. This is the default.

„ Offline – Prevents the port from receiving signal and 

accepting a device login.

„ Diagnostics – Prepares the port for testing and pre-

vents the port from accepting a device login.

„ Down – Disables the port by removing power from 

the port lasers.