Q-Logic 5802V Manuel D’Utilisation

9 – Device Security Configuration

Configuring the Security Database

59263-01  A

9-7

A

You can configure how the security database is applied to the switch and 
exchanged with the fabric through the security configuration parameters. The 
following security configuration parameters are available through the 

 command:

„

AutoSave–This parameter enables or disables the saving of changes to 
active security set in the switch’s non-volatile security database.

„

FabricBindingEnabled–This parameter enables or disables the configuration 
and enforcement of fabric binding on all switches in the fabric. Fabric binding 
associates switch worldwide names with a domain ID in the creation of ISL 
groups.

If AutoSave is False, you can revert device security changes that have been 
received from another switch through the activation of a security set, or merging of 
fabrics. Enter the 

 Restore command to replace the volatile security 

database with the contents of the non-volatile security database.

To restore the security configuration to its factory values, you can enter the 

Config or Reset Factory command. Notice however, that these commands 

restore other aspects of the switch configuration also.