Q-Logic 5802V Manuel D’Utilisation

13 – Simple Network Management Protocol Configuration

Managing the SNMP Service

13-2

59263-01  A

S

You control the SNMP service SNMPEnabled parameters through the 

 or 

 commands. Refer to 

 for more information.

Enter the 

 command to enable SNMP as shown in the 

following example:

SANbox #> admin start

SANbox (admin) #> set setup services

  A list of attributes with formatting and current values will follow.

  Enter a new value or simply press the ENTER key to accept the current value.

  If you wish to terminate this process before reaching the end of the list

  press 'q' or 'Q' and the ENTER key to do so.

  PLEASE NOTE:

  -----------

  * Further configuration may be required after enabling a service.

  * If services are disabled, the connection to the switch may be lost.

  * When enabling SSL, please verify that the date/time settings

    on this switch and the workstation from where the SSL connection

    will be started match, and then a new certificate may need to be

    created to ensure a secure connection to this switch.

  TelnetEnabled       (True / False)   [True ]

  SSHEnabled          (True / False)   [False]

  GUIMgmtEnabled      (True / False)   [True ]

  SSLEnabled          (True / False)   [False]

  EmbeddedGUIEnabled  (True / False)   [True ]

  SNMPEnabled         (True / False)   [True ]

  NTPEnabled          (True / False)   [False]

  CIMEnabled          (True / False)   [False]

  FTPEnabled          (True / False)   [True ]

  MgmtServerEnabled   (True / False)   [True ]

  CallHomeEnabled     (True / False)   [True ]

  Do you want to save and activate this services setup? (y/n): [n]

You can display the SNMPEnabled parameters using the 

 or 

 commands.