Q-Logic 5802V Manuel D’Utilisation

14 – Command Reference

Fctrace

59263-01  A

14-23

A

Displays the path from an initiator device port in the fabric to a target device port in 
the same zone. To trace the path between two initiator ports, you must disable the 
I/O StreamGuard feature. Use the 

 command to change the 

IOStreamGuard parameter.

Path information includes the following:

„

Domain IDs

„

Inbound port name and physical port number

„

Outbound port name and physical port number

None

The Fibre Channel port from to begin the trace. [port_source] can have the 
following formats:
„

6-character hexadecimal device Fibre Channel address (hex). Enter 
addresses with or without the “0x” prefix.

„

16-character hexadecimal worldwide port name (WWPN) with the format 
xx:xx:xx:xx:xx:xx:xx:xx or xxxxxxxxxxxxxxxx.

The Fibre Channel port at which to end the trace. [port_destination] can have the 
following formats:
„

6-character hexadecimal device Fibre Channel address (hex). Enter 
addresses with or without the “0x” prefix.

„

16-character hexadecimal worldwide port name (WWPN) with the format 
xx:xx:xx:xx:xx:xx:xx:xx or xxxxxxxxxxxxxxxx.

Maximum number of hops before stopping the trace. If you omit [hop_count], 20 
hops is used.

This command requires the SANdoctor license key. To purchase a license 
key, contact your authorized maintenance provider or authorized reseller. 
Use the 

 command to install a license key.