Q-Logic 5802V Manuel D’Utilisation

14 – Command Reference

Set Config Switch

59263-01  A

14-95

A

Sets the switch configuration parameters. The changes you make with this 
command are not retained when you reset or power cycle the switch unless you 
save them using the 

 Save command.

Admin session and a Config Edit session

set config switch
This command initiates an editing session in which to change switch configuration 
settings. The system displays each parameter one line at a time and prompts you 
for a value. For each parameter, enter a new value or press the Enter key to 
accept the current value shown in brackets. 

 describes the switch 

configuration parameters.

AdminState

Switch administrative state.

„ Online – Activates and prepares the ports to send data. 

This is the default.

„ Offline – Prevents the ports from receiving signal and 

accepting a device login.

„ Diagnostics – Prepares the ports for testing and prevents 

the ports from accepting a device login.

„ Down – Disables the ports by removing power from the 

port lasers.

BroadcastEnabled

Broadcast. Enables (True) or disables (False) forwarding of 
broadcast frames. The default is True.

InbandEnabled

Inband management. Enables (True) or disables (False) the 
ability to manage the switch over an ISL. The default is True.

FDMIEnabled

Fabric Device Monitoring Interface. Enables (True) or dis-
ables (False) the monitoring of target and initiator device 
information. The default is True.

FDMIEntries

The number of device entries to maintain in the FDMI data-
base. Enter a number from 0–1000. The default is 1000.

DefaultDomainID

Default domain ID. The default is 1.

DomainIDLock

Prevents (True) or allows (False) dynamic reassignment of 
the domain ID. The default is False.

SymbolicName

Descriptive name for the switch. The name can be up to 32 
characters excluding #, semicolon (;), and comma (,). The 
default is SANbox.