Q-Logic 5802V Manuel D’Utilisation
14 – Command Reference
Set Port
59263-01 A
14-107
A
Set Port
Sets port state and speed for the specified port temporarily until the next switch
reset or new configuration activation. This command also clears port counters.
reset or new configuration activation. This command also clears port counters.
Authority
Admin session
Syntax
set port clear
or
set port [port_number]
clear
speed [transmission_speed]
state [state]
speed [transmission_speed]
state [state]
Keywords
[port_number]
Specifies the port. Ports are numbered beginning with 0.
clear
Clears the counters on all ports or the port given by [port_number].
speed [transmission_speed]
Specifies the transmission speed for the specified port. Choose one of the
following port speed values:
following port speed values:
1Gb/s
One gigabit per second. 8-Gbps SFPs do not support the 1-Gbps setting.
Setting a port to 1-Gbps that has an 8-Gbps SFP will down the port.
Setting a port to 1-Gbps that has an 8-Gbps SFP will down the port.
2Gb/s
Two gigabits per second.
4Gb/s
Four gigabits per second.
8Gb/s
Eight gigabits per second.
10Gb/s
Ten gigabits per second. This applies only to ports 20–23.
20Gb/s
Twenty gigabits per second. This applies only to ports 20–23 with a 20-Gbps
license key.
license key.