Q-Logic 5802V Manuel D’Utilisation

4 – Network Configuration

Verifying a Switch in the Network

4-6

59263-01  A

S

You can verify that a switch is communicating in the network using the 

command. The following example successfully tests the network for a switch with 
IP address 10.20.11.57.

SANbox #> ping 10.20.11.57

  Ping command issued. Waiting for response...

SANbox #>

  Response successfully received from 10.20.11.57.

If the switch was unreachable, you would see the following display.

SANbox #> ping 10.20.11.57

  Ping command issued. Waiting for response...

  No response from 10.20.11.57. Unreachable.

To modify IP Security, you must open an Admin session with the 

 Start 

command. An Admin session prevents other accounts from making changes at 
the same time through Telnet, QuickTools, Enterprise Fabric Suite 2007, or 
another management application. You must also open an Ipsec Edit session with 
the Ipsec Edit command. The Ipsec Edit session provides access to the 

, 

 commands with which you make modifications 

to the IP Security configuration.

SANbox #> admin start

SANbox (admin) #> ipsec edit

SANbox (admin-ipsec)#> ipsec . . .

SANbox (admin-ipsec)#> ipsec policy . . .

SANbox (admin-ipsec)#> ipsec association. . .

When you are finished making changes, enter the Ipsec Save command to save 
and activate the changes and close the Ipsec Edit session. Changes take effect 
immediately.

SANbox (admin-ipsec)#> ipsec save

To close the Ipsec Edit session without saving changes, enter the Ipsec Cancel 
command.

SANbox (admin-ipsec)#> ipsec cancel

The Admin End command releases the Admin session for other administrators 
when you are done making changes to the switch.