Q-Logic 5802V Manuel D’Utilisation
6 – Port Configuration
Modifying Port Operating Characteristics
6-8
59263-01 A
S
You can configure all ports based a specified source port using the
Set Config Ports command. The following example configures ports 0–23 based
on port 3.
Set Config Ports command. The following example configures ports 0–23 based
on port 3.
SANbox #> admin start
SANbox (admin) config edit
SANbox (admin) #> set config ports 3
.
.
.
SANbox (admin-config)#> config save
SANbox (admin)#> config activate
SANbox (admin)#> admin end
The following example temporarily changes the port 1 administrative state to
Down:
Down:
SANbox #> admin start
SANbox (admin) #> set port 1 state down