Alpha Vision Tech MPS48-7M Manuel D’Utilisation

21

021-511-B4-002, Rev. B

• #2 

fl athead screwdriver

• Electrical 

tape

1.  Loosen the retaining screw on the battery retaining bracket and move the bracket clear of 

the battery shelf.

2.  If using the battery heater mat option, verify the input voltage printed on the battery 

heater mat label corresponds to the selected input voltage (default 240V). Place the 
battery heater mat on the shelf. Connect the 3-pin connector to the Battery Heater 
connection on the power module.

3.  Place two 7.2Ah batteries on the battery shelf and 

tape the battery temperature sensor to the side of the 
second battery. Place the remaining two batteries on 
the battery shelf.

4.   Replace the battery retaining bracket and secure.

5.  Connect the batteries, leaving the far left negative 

terminal unconnected. The positive battery connections 
are fi tted with a safety tab to prevent misconnection.

CAUTION!

Connecting 240Vac to a battery heater mat rated 120Vac will damage the heater mat. 

Make network connections and complete any other connections on the customer and service 
AC side at this time. When all connections are verifi ed proceed to Section 5.0, Operation.

Tape Sensor to Battery

Leave Disconnected