ADC Power Distribution Products Manuel D’Utilisation

ADCP-80-526 • Issue 6 • December 2006

11. Connect the input power cables to the office battery power source in accordance with

applicable local electrical codes and/or National Electrical Codes.

    

Install the rear protective covers over the connectors at the rear of the fuse platform when all the
wiring connections are completed. To identify the covers, see 

To install the plastic protective cover, thread the four 3/8-inch (9.53 mm) long, Phillips drive, 6-
32 pan-head screws into the standoffs located between the output power screw-down terminal
strips. Rotate each screw approximately two turns to get it started. Hold the cover so the
lettering is oriented properly and then install the cover over the screw heads. Slide the cover to
the left and then tighten the screws. 

Color-coded fuse designation pins (accessory item) are available for GMT fuses. The pin color
corresponds to the color of the fuse indicator. Insert the appropriate color-coded pins (accessory
item) into the corresponding holes in each GMT fuse holder as required. 

Caution:  Do not apply power to the fuse platform until instructed to do so for testing (see

18870-A