Blomberg TKF 7230 Manuel D’Utilisation

Page de 44
7 - EN
C  Exhaust of humid air from the dryer 
into the room is inconvenient. It may 
damage the walls and furniture in the 
room.
C  The ventilation hose can be routed 
outdoors via a window or it can be 
connected to the air outlet in the 
bathroom.
C  Air outlet hose must be extended 
directly to the outdoors. There must 
be a small number of elbows as not to 
hinder air ventilation.
C  To prevent water accumulation in the 
hose, make sure that it is not folded 
on the floor.
B  The air ventilation hose should not be 
connected to the chimney of a stove 
or a fireplace. 
B  Do not operate your machine at the 
same time with heaters such as a coal 
or gas stove. Airflow may cause the 
chimney to flare up. Airflow may cause 
the chimney to flame up.
Connection to a water drain 
(for products equipped with a 
condenser and heat pump)
In products equipped with a condenser 
unit the water accumulated during the 
drying cycle is collected in the water tank. 
You should drain the accumulated water
after each washing cycle.
You can directly send the accumulated
water out through the water drain hose 
supplied with the machine instead of 
periodically draining the water collected in 
the water tank.
Connecting the water drain hose;
1.   Remove the hose on the machine by 
pulling it out from its end.  Do not use 
any tools to take out the hose. 
2.   Connect the special drain hose 
supplied with the machine to the pipe 
fitting.
3.   The other end of the drain hose 
can be directly connected to the 
wastewater drain or to the washbasin. 
The fitting must always be secured in 
all types of connections. Your house
may be flooded if the hose gets out of 
its housing during water discharge.
C  When you direct the water drain out, 
“Water Tank” warning LED will light up
at the end of each program.
Important:
•  The hose should be attached to a
height of maximum 80 cm.
•  You must be careful not the pinch or
bend the hose. 
•  The end of the hose should not be
bent, it should not be stepped on and 
it must not be folded between the 
drain and the machine.
Electrical connection
Connect the machine to an earthed outlet 
protected by a fuse of suitable capacity.
Important:
•  Connection should comply with
national regulations.
•  Power cord plug must be within easy
reach after installation.
•  The voltage and the allowed fuse
protection are specified in the section 
“Technical Specifications”.