Zebra Technologies 105SLTM Manuel D’Utilisation
Routine Maintenance
Lubrication
Lubrication
108
11342L-001 Rev. A
105SL User Guide
6/30/06
Lubrication
Cleaning Schedule
Cleaning your printer regularly maintains print quality and may extend the life of the printer.
The recommended cleaning schedule is shown in
The recommended cleaning schedule is shown in
. See the following pages for
specific procedures.
Caution •
No lubricating agents other than Zebra-supplied, silicon-only lubricants should
be used on the spindle felt clutches of this printer. Other commercially available lubricants
damage the finish and mechanical parts.
damage the finish and mechanical parts.
Caution •
Use only the cleaning agents indicated. Zebra is not responsible for damage
caused by any other fluids being used on this printer.
Table 11 • Recommended Printer Cleaning Schedule
Area
Method
Interval
Printhead
Solvent*
Perform these procedures at the following times:
• When
CLEAN HEAD NOW
appears.
• Direct Thermal Print Mode: After every roll of
labels or 500 ft (150 m) of fanfold labels.
• Thermal Transfer Print Mode: After every roll
(1500 ft or 450 m) of ribbon.
Platen roller
Solvent*
Transmissive (media) sensor
Air blow
Black mark sensor
Air blow
Media path
Solvent*
Ribbon sensor
Air blow
Label-available sensors
Air blow
Monthly
Tear-off/peel-off bar
Solvent*
Snap plate
Solvent*
As needed
Cutter
Solvent*
* Zebra recommends using Preventive Maintenance Kit (part number 47362). In place of this kit, you may use a clean swab
dipped in a solution of isopropyl alcohol (minimum 90%) and deionized water (maximum 10%).