Sharp AM-300 Manuel D’Utilisation
Messages and Signals
151
10. T
ro
u
b
le-
shooting
AM-400 only:
MEMORY IS FULL
If faxes have been received to memory because
printing is not possible (an additional message will
indicate the problem), resolve the problem so that
printing can continue (see Substitute Reception to
Memory on page 102).
If you are attempting to send a fax, see If the memory
becomes full on page 74.
If you are copying, see If MEMORY IS FULL appears
on page 58.
printing is not possible (an additional message will
indicate the problem), resolve the problem so that
printing can continue (see Substitute Reception to
Memory on page 102).
If you are attempting to send a fax, see If the memory
becomes full on page 74.
If you are copying, see If MEMORY IS FULL appears
on page 58.
OUTPUT TRAY OFF
The output tray is not attached correctly. Attach it as
explained on page 14. The machine will not operate if
the output tray is not attached correctly.
explained on page 14. The machine will not operate if
the output tray is not attached correctly.
PAPER JAMMED
The paper is jammed. See page 155.
PAPER MISMATCHED
This appears after printing if the size of the printed
image did not match the paper size on some pages of
the job. Check the printed pages and reprint as
needed.
image did not match the paper size on some pages of
the job. Check the printed pages and reprint as
needed.
SET BYPASS PAPER /
SIZE: XXXX
(alternating messages; a
paper size appears in
“XXXX”)
SIZE: XXXX
(alternating messages; a
paper size appears in
“XXXX”)
Paper must be inserted in the bypass tray for a print
job or copy job that requires use of the bypass tray.
Insert the indicated size of paper in the tray.
job or copy job that requires use of the bypass tray.
Insert the indicated size of paper in the tray.
SYSTEM ERROR [XX]
(a number appears in
“XX”)
(a number appears in
“XX”)
If this message appears, unplug the power cord, wait
about 10 seconds, and then plug it back in. If the
message still appears, unplug the power cord and call
for service.
about 10 seconds, and then plug it back in. If the
message still appears, unplug the power cord and call
for service.
TONER EMPTY
The toner cartridge must be replaced. Printing will be
possible (although the output will be increasingly
faint) until a fax is received. Once a fax is received, it
will be held in memory and printing will not be
possible until the toner cartridge is replaced.
possible (although the output will be increasingly
faint) until a fax is received. Once a fax is received, it
will be held in memory and printing will not be
possible until the toner cartridge is replaced.
TONER NEAR EMPTY
The toner cartridge is almost out of toner
(approximately 200 pages can be printed).
(approximately 200 pages can be printed).
DATE/TIME UNSET
The date and time need to be set (see page 48). Note
that the date and time settings will be lost if the
machine is unplugged or a power failure occurs.
that the date and time settings will be lost if the
machine is unplugged or a power failure occurs.